Woca Master Filler Aqua 5 liters,

*** PLEASE NOTE NO LONGER AVAILABLE. BEING REPLACED BY THE STRATO EASYFILLER 101, TECHNICALLY THE SAME PRODUCT ALSO 5 KILO AND ALSO THE SAME PRICE.

Master Filler Aqua is a thick, easy-to-sand, water-based filler for joints, holes, and cracks in wooden parquet floors, such as those in brick or herringbone patterns. The joint sealant provides a uniform finish, is extremely easy to work with, and will not crack because it is elastic and moves with the wood.

Capacity is 5 liters.

• Easy to sand once cured
• Water-based
• Thick elastic consistency
• Neutral scent
• Drying time 60 min.
• Consumption 15-20 m2 per litre.
• Apply with the stainless steel spatula below

Use Woca Master Filler Aqua,

It is important that both the wood and the filler are at least 15°C (preferably around 20°C) with a
average humidity of about 50%. Make sure the room is well ventilated for
optimal evaporation and drying time. The surface must be completely clean, dry, and free of dirt,
wax, grease, polish, etc. Dirt and irregularities should be removed with a sander.
removed. If necessary, clean the surface with WOCA Intensive Wood Cleaner, diluted 1:20,
before you start sanding.
Don't forget to test the product for suitability by first testing a small piece of wood with the
to edit wood filler.

Fine sanding Grit 60-80

Treat with Woca Master Filler Aqua,

Shake product well before use. Mix Master Filler Aqua and the sanding residue until smooth and
soft paste. The structure of the filler can be adjusted using the fine or coarse
Sanding residue. Distribute the filler evenly using a stainless steel applicator.
Remove as much excess filler as possible before it begins to harden. Repeat the process
for larger joints, holes, and cracks, if necessary. Sand the surface with sandpaper
with grit 100-120, once the surface is dry. The surface can then be varnished with a
of WOCA lacquers, according to the product instructions.

--TECHNICAL INFORMATION...