Woca Hardwax Oil Extreme,

Hardwax Oil Extreme is a low-odor product for the oil treatment of wooden floors. It combines all the benefits of oil and wax in one product, providing an extremely robust and resistant surface that is well protected against spills and stains. Hardwax Oil Extreme emphasizes the natural glow of the wood, creating a comfortable non-slip surface that is easy to maintain.

Benefits of Woca Hardwax Oil Extreme,

• Good resistance to water, coffee, tea and red wine
• Resistant to scratches and stains
• Gives the wood a natural look and a breathable surface
• Easy to maintain using the associated maintenance products

Apply with the special paint roller that you see below, and maintain it according to the Woca maintenance plan.

--TECHNICAL INFORMATION--

-CLICK HERE FOR THE ONLY CORRECT WOCA MAINTENANCE PLAN-

Packaging: 2.5 litres
Consumption: 8-12 m2/liter, depending on wood type
Available: in Natural
Drying time: 8-10 hours for each coat.

Instructions for use Woca Hardwax Oil Extreme,

It is important that the product, room and floor have a temperature between 15 °C and 30 °C and that the humidity is approximately 50%. The wood moisture should not exceed 12%. Make sure the room is well ventilated for optimal evaporation and drying time.
The floor must be free of dirt, grease, wax and sanding residues. Previously treated floors should be sanded down to bare wood with 120-150 grit. Vacuum thoroughly and then, if necessary, wipe the floor clean with a well-wrung, water-soaked cloth. Hardwax Oil Extreme is ready to use.

1. Hardwax Oil Extreme must be thoroughly stirred before and during use. Containers with different batch numbers must be mixed to avoid color mismatch.

2. Using a short-haired paint roller (3-4 mm) (See below), apply a thin and even layer of oil to a small area of the floor (5-10 m2). Distribute the oil thoroughly. Leave the oil on the surface for 5-10 minutes while the oil shines. If the oil soaks into the wood quickly, apply more oil. Please note: After approximately 15 minutes, Hardwax Oil Extreme starts sealing the surface.

3. Scrub the surface with a white or beige scrub pad until the wood appears saturated. Then wipe with a clean, lint-free cotton cloth to remove excess oil before moving on to the next section. The surface should not appear wet and no excess oil should remain on the surface.

4. Allow the floor to dry for 8-10 hours. The drying time depends on the temperature, humidity and amount applied. Lower temperatures and/or higher humidity can extend the drying time.

5. Repeat steps 2-3 if a second coat of oil is needed or if you want a higher gloss or harder surface. A single coat of oil is normally sufficient for previously oiled surfaces.

6. Clean your tools with WOCA oil thinner.

7. The newly oiled floor can be used carefully the next day and is fully cured after 7 days under normal indoor conditions. Do not expose the floor to water for the first 7 days or clean the floor while the oil hardens.

Maintain Woca Hardwax Oil Extreme,

Regular cleaning: Eco Multi Cleaner (daily) and monthly / 2 monthly use the WOCA Natural Soap and/or WOCA Oil Conditioner.
Regular maintenance: WOCA Maintenance Oil. if a new layer is needed, use the Hardwax Oil Extreme and/or WOCA Maintenance Gel if necessary.